Page 3
TG50E
Section B: Basic Troubleshooting
Basic Troubleshooting
1.
Check connections at B– cables, B+ cables,
B+ interconnect cable, B– interconnect cable, and
alternator-to-regulator harness. Repair or replace
any damaged component before troubleshooting.
2.
Connections must be clean and tight.
3.
If batteries are discharged, recharge or replace
batteries as necessary. Electrical system cannot
be properly tested unless batteries are charged
95% or higher. In addition, open circuit voltages
must be within ± 0.2 V.
4.
Connect red lead of DMM to alternator anti-drive
end B+ terminal and black lead to alternator
anti-drive end B– terminal. Clamp inductive
ammeter on anti-drive end B+ cable.
5.
Observe charge voltage at batteries with engine
running (nom. 27-28 V).
If charge voltage is above
32 V, immediately shut
down system. Electrical
system damage may occur if
charging system is allowed
to operate at excessive
voltage. Go to Table 1.
If voltage is at or below regulator setpoint, let
charging system operate for several minutes to
normalize operating temperature.
6.
Charge voltage should increase and charge amps
should decrease. If charge voltage does not in-
crease within ten minutes, continue to next step.
7. are considered fully charged if charge
voltage is at regulator setpoint and charge amps
remain at lowest value for 10 minutes.
8. is not performing properly,
go to Chart 1, page 4.
SYMPTOM
ACTION
TABLE 1 – System Conditions
Check: loose drive belt; low bat-
tery state of charge.
Check: current load on system
is greater than alternator
can produce.
Check: defective wiring or poor
ground path; low regula-
tor setpoint.
Check: defective alternator or
regulator.
Check: wrong regulator.
Check: high regulator setpoint.
Check: defective regulator.
Check: alternator.
Check: broken drive belt.
Check: battery voltage at alterna-
tor output terminal.
Check: defective alternator
or regulator.
Low Voltage Output
High Voltage Output
No Output
Preliminary Check-out
Check symptoms in Table 3 and correct if necessary.
Tools and Equipment for Job
• Digital Multimeter (DMM)
• Ammeter (digital, inductive)
• Jumper wires
Identication Record
List the following for proper troubleshooting:
Alternator model number ________________________
Regulator model number _______________________
Setpoint listed on regulator _____________________
CAUTION
(6 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales