
Page 5
TG0043B
Section 3: Advanced Troubleshooting
(CONT’D)
Test for battery voltage at alternator 28 V B+ terminal. Does battery voltage exist?
Ye s
No
Repair vehicle wiring as necessary. Continue test.
Run engine and re-test charging circuit for operation.
Chart 1 – 28 V LED Flashing AMBER – No 28V Alternator Output – Test Charging Circuit
Jumper 28 V B+ terminal on alternator to E terminal on regulator. Wait 10 seconds. Run engine. Does
alternator charge and is 28 V LED flashing GREEN?
Yes
No
Turn off engine, leave key on. Remove jumper wire. Go to E
terminal on regulator. Test for battery voltage going into E
terminal from battery. Does battery voltage exist?
Ye s
No
STATIC TEST – MASTER SWITCH ON, KEY ON, ENGINE OFF
Repair vehicle circuit to E terminal.
Vehicle charging circuit test is complete.
TT
TT
T
TT
TT
T
TT
TT
T
TT
TT
T
TT
TT
T
TT
TT
T
Ye s
Turn off engine, leave key on. Connect
jumper wire from pin A in alternator-to-
regulator harness plug to B– terminal on
alternator. Spark will occur. Touch steel
tool to shaft to detect significant magne-
tism. is shaft magnetized?
No
TT
TT
T
TT
TT
T
TT
TT
T
Alternator is
defective.
TT
TT
T
Figure 3 – Alternator-to-Regulator Harness Plug
PIN CONNECTIONS
Pin A F–
Pin B SCR Gate
Pin C B–
Pin D 28 V B+
Pin E 14V B+
Pin F AC
Alternator is
defective.
TT
TT
T
TT
TT
T
Ye s
Set DMM to diode test. Connect DMM red
lead to pin F on harness plug. Connect
black leak to alternator B+ terminal.
Reverse leads. Meter should read OL in
one direction, and voltage drop in the other
direction. Do tests prove out?
No
Alternator is
defective.
TT
TT
T
Regulator is
defective.
TT
TT
T
Ye s
No
Connect DMM red lead to pin D on harness
plug. Connect black lead to pin C on same
plug. Does battery voltage exist?
When performing the
following test, connect
jumper wire away from
pin A or not at pin A.
Spark may erode pin.
CAUTION
Comentarios a estos manuales